Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Stepper motors won't move
02-07-2018, 04:51 AM
Post: #1
Stepper motors won't move
I can get connection with the inkscape app and move the servo(pen) up and down but I can not get any movement on the steppers when I use the manual tab or if I try to plot. When I enable the steppers on the manual tab neither stepper seems to energize.
I believe i have the steppers hooked up to the shield properly since I am using the same shield on the Makeangelo drawbot, but I could have then screwed up. Any help would be appreciated.
I have an Arduino Leonardo with a Adafruit (MH Electronics) motor shield. I have Ejjduino_Arduino loaded on the Leonardo and I am running inkscape .91 with release 2.4.0 of Eggbot control installed.
Will anyone phelp me with the adafruit motorshield or do I need to order one of your motor shields?
I also have knockoff cnc motor shield that I used for other projects, but they do not have screw terminals and the steppers I have are flying leads

Curt
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)