Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Help with compiling code
01-31-2018, 03:02 PM
Post: #1
Help with compiling code
Hey everyone!
My robot is finished! Now I just need help with compiling the code! When I open up the code and try to verify it, I get errors like

'OSC_init' was not declared in this scope

And
MPU6050_setup was not declared in this scope

What am I doing wrong?

Thank you
Find all posts by this user
Quote this message in a reply
01-31-2018, 05:33 PM
Post: #2
RE: Help with compiling code
Looks like all the files are not located inside the same folder. The Arduino will look for them there. Extract all the *.ino files (B-robot_evo2.ino, control.ino...etc) into the same folder and try again
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)