Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Inverted raise/lower
01-22-2018, 04:52 AM (This post was last modified: 01-22-2018 04:57 AM by julianm3.)
Post: #1
Inverted raise/lower
If I go through the Arduino IDE the TP (toggle pen) command works correctly. But with the Inkscape extension Toggle pen has no effect unless the numbers are changed first.

Manual 'Raise the Pen' and 'Lower the Pen' do the opposite, and the Options-->Reverse motion of motor 1 has no effect.

Any thoughts on how I could attach a debugger to the inkscape extension code? Or at least get console output for debug messages?

Thanks in advance

Figured out the inverse problem: The 'Pen Up' number needs to be less than the 'Pen Down' number.
Find all posts by this user
Quote this message in a reply
01-23-2018, 10:40 AM
Post: #2
RE: Inverted raise/lower
Nope. Sorry. But I do not fully understand the problem. There is an issue with the servo (working backwards) and one motor is spinning in the opposite direction?
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)