Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Initial Connection Issues - please help.....
12-26-2017, 11:07 PM
Post: #1
Initial Connection Issues - please help.....
Please Help/...

Have the yellow flashing light. Run the web config wizard.

go to JJROBOT19 (there is no JJROBOTS_IBB)

press the green putting . goes to 198.168.4.1 then safari comes up with message - can't connect to internet. no pop up screen to enter the house wifi etc.

really frustrated. Just spent 4 hours putting it together with my 11 yr old daughter only to fail at the last hurdle.....

please help... anyone...

Colin
Find all posts by this user
Quote this message in a reply
12-27-2017, 09:59 AM
Post: #2
RE: Initial Connection Issues - please help.....
Hi Colin!
It looks like the Arduino still have the B-robot EVO code inside. If you want to create the iboardbot you will need to upload the proper Arduino code to the board. Take a look at the assembly page here:
https://www.jjrobots.com/iboardbot-assem...tructions/ and go to the very end of that page. You will find there the iboardbot´s Arduino code and instructions

Let us know if you have problems
Visit this user's website Find all posts by this user
Quote this message in a reply
12-27-2017, 10:00 AM
Post: #3
RE: Initial Connection Issues - please help.....
Looks like you are not using the right CODE colin. Upload the iboardbot´s arduino code to the Arduino board.
Find all posts by this user
Quote this message in a reply
12-28-2017, 01:32 PM
Post: #4
RE: Initial Connection Issues - please help.....
Thanks. Uploaded the revised file to the Arduino - now works. Thank you for the help. Have some different issues now but will start a seperate post. thanks again.

For others -This is due to me ordering the STEM kit which of course can only come with one model’s software uploaded to the Arduino. To JJrobots I would suggest a piece of paper in the box stating which software was loaded would be helpful.

Colin
Find all posts by this user
Quote this message in a reply
12-29-2017, 09:34 AM
Post: #5
RE: Initial Connection Issues - please help.....
Hi Colin. Noted. Thanks for the feedback. We will attach a sticker to the electronics with a note stating which code has been already uploaded to the Leonardo.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)