Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Y-axis skipping / drifting upwards
10-15-2017, 09:47 PM (This post was last modified: 10-15-2017 10:25 PM by dbrgn.)
Post: #1
Y-axis skipping / drifting upwards
I have the issue that the home position is drifting upwards after a print. So if I push down the pen to the bottom left corner and then do a print, the x-position is at 0 but the y position is a few millimeters above.

What could be the issue here? Some belts slipping? Do I need to tighten something?

Hm, I think tightening the Y-belt helped Smile I'll do a few test runs tomorrow to see if it also still works fine after 10-20 prints.
Find all posts by this user
Quote this message in a reply
10-16-2017, 09:40 AM
Post: #2
RE: Y-axis skipping / drifting upwards
Yes, check the friction of the Y axis and the belt too (just in case)
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)