Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
problem with the sketch
07-18-2017, 05:34 AM
Post: #1
problem with the sketch
As soon as I upload the sketch using the arduino IDE. the servo triggers all the way up and continues to fire. grinding against the top position.

any ideas?
Find all posts by this user
Quote this message in a reply
07-18-2017, 09:24 AM
Post: #2
RE: problem with the sketch
Check:
1) You have selected the correct Board: arduino Leonardo
2) Disconnect everything from the Arduino and try to upload the code
3) Double check the servo connection: they might be connected backwards
Visit this user's website Find all posts by this user
Quote this message in a reply
07-19-2017, 05:23 AM
Post: #3
RE: problem with the sketch
awesome...

#2 did it. not sure of the logic why but... When I disconnected the servo, uploaded the sketch and then re-connected the servo, it started working.

I am having the issue another poster had with the servo being inverted. "Pen up" lowered the pen and visa versa, but was able to correct by inverting the values in the set-up screen as recommended in that other thread.

Thanks
Find all posts by this user
Quote this message in a reply
07-19-2017, 07:12 PM
Post: #4
RE: problem with the sketch
You are more than welcome Shoeshine ;-)
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)