Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
New second self made BROBOT
04-30-2017, 07:48 AM
Post: #1
Wink New second self made BROBOT
                Hello to BROBOT fans.
I have assembled one standard kit, with very good results, and also modified it to run outdoor, of corse sporting a suitable big wheels. But the appetite comes with eating, so i decide to make a second one, this time by a self made frame. All parts was from 5/6mm Forex, very easy to cut and thread, assembled by 3mm screw. The wheels and hubs was from Pololu, a little modified to accept the 5mm stepper motors shaft. Electronics standard and lipo 3S 2000mAh with balancing connector. In this case i downloaded the new BROBOT_EVO2_17 software, to find the differences from the old version. The response was very remarkable, i can say "fast and furious", especially in PRO mode, where my hand on my smartphone find difficult to follow the robot movements. The stability was remarkable also, with a big angle of deflection REW and FW at maximum speed. In my opinion it's a big step respect to the first version.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)