Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Lifting servo no working?
08-02-2016, 10:59 PM
Post: #1
Lifting servo no working?
Hello

I've finally got round to assembling my iboardbot all works except for the lifting servo, there is no movement.
I've checked the connections are tight, including the extension and swapped the eraser and lifting leads round on the board, so the eraser moves when the lifting leg is meant to, so I guess it is servo side.

Any suggestions?
Find all posts by this user
Quote this message in a reply
08-03-2016, 03:17 PM
Post: #2
RE: Lifting servo no working?
I had a similar problem. After checking the extender servos cables I realised one was not well connected but it looks you have already checked that...
Have you swapped the servos just to check if the servo is in working conditions? I mean, connect the eraser servo cable to the lifting servo and vice-versa.
Find all posts by this user
Quote this message in a reply
08-03-2016, 10:04 PM
Post: #3
RE: Lifting servo no working?
Yes I swapped the two servos round on both the board and the extender cables. And got the eraser to move when the lifter should!
Find all posts by this user
Quote this message in a reply
08-04-2016, 08:41 AM
Post: #4
RE: Lifting servo no working?
So, that means servo is dead, isnĀ“t it? if you bought the KIT contact jjrobots guys. I never had issues with replacements (and I have bought more than 6 kits to them)
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)