Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Power for BB-Robot
11-14-2015, 02:14 PM
Post: #4
RE: Power for BB-Robot
I replaced the capacitor I blew up with a tantalum cap and all is working fine.

Another project I made had the power going into a screw-terminal connector on the motor driver board, and then powering the Arduino Uno through bus pins. The barrel connector on the Uno was NOT used. I thought this was the same thing. It made sense because battery holders don't normally come with barrel connectors, only bare wires to hook up to screw terminal.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Power for BB-Robot - queenidog - 11-12-2015, 06:58 PM
RE: Power for BB-Robot - KomX - 11-13-2015, 06:52 AM
RE: Power for BB-Robot - JohnQ - 11-13-2015, 01:12 PM
RE: Power for BB-Robot - queenidog - 11-14-2015 02:14 PM
RE: Power for BB-Robot - Pat78 - 11-14-2015, 05:04 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)