Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Standard Servo possible??
06-05-2020, 03:05 PM
Post: #1
Standard Servo possible??
For my new body for b-robot I need to know if it is possible to use an standard servo instead of the original 9g mini servo? The Devia board provides 1,5A pro servo output, but don't know if this enough.
Find all posts by this user
Quote this message in a reply
06-07-2020, 01:51 PM
Post: #2
RE: Standard Servo possible??
You can use any servo you want but make sure it is not demanding more than 1.5 A. If it is close to that value I would recommend using a heatsink on top of the 5V regulator on the board.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)