Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
My experience with the slider
06-04-2020, 09:11 PM
Post: #13
RE: My experience with the slider
(06-04-2020 09:03 PM)MisterMaker Wrote:  Quick update, I reprinted the mounting part to remove the friction, and results where that it was too loose. Sad
Which is bit of a bummer.

The precision when 3D printing is a hit or miss. Even using same filament brand but from a different batch provide different results.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: My experience with the slider - JohnQ - 06-03-2020, 09:15 AM
RE: My experience with the slider - JohnQ - 06-04-2020 09:11 PM
RE: My experience with the slider - JohnQ - 06-16-2020, 09:47 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)