Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
My experience with the slider
06-01-2020, 09:32 AM (This post was last modified: 06-04-2020 08:59 PM by MisterMaker.)
Post: #7
RE: My experience with the slider
(05-31-2020 04:30 PM)JJrobots JP Wrote:  
(05-30-2020 10:06 PM)MisterMaker Wrote:  So I printed my new mounting plate. And it worked out perfectly.
I could adjust the tension on the v-wheels from too loose to too tight.
Now I had some Vibrations from friction, but I am going to let it run for a while and see how it goes then.
Maybe I shouldn't have used 3D printed V-wheels.

This is a brilliant idea. Could you upload the stl model of the carriage, so I can test it?
The precision when 3D printing is always a problem as it depends on the filament, temperature even nozzle diameter. So a method to get rid of those "inaccuracies" is always welcome.
I have added the stl, but be aware I have done some last minute adjustment based on my last test. I noticed the parts was sliding over the top of the profile. So I added a bit more space above the profile.
I tested the 3D model and it didn't work...
[attachment=507]
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: My experience with the slider - MisterMaker - 06-01-2020 09:32 AM
RE: My experience with the slider - JohnQ - 06-03-2020, 09:15 AM
RE: My experience with the slider - JohnQ - 06-04-2020, 09:11 PM
RE: My experience with the slider - JohnQ - 06-16-2020, 09:47 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)