Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Stepper motors wont move
03-20-2019, 01:56 AM
Post: #1
Stepper motors wont move
Ok everyone need some help. Trying to finish my eggbot. The sevo motor works just fine. Inkscape connects and move the servo motor with no issues. The two stepper motors do not move. I know which wire goes from the stepper motor for A+,A-,B+,B- However I have no clue on the JJ Board that the wires go to. I have tried all of the combinations I can think of but no luck. I have seen on the forum where people have replaced the stepper drivers and that fixes the issue but I want to make sure I am wiring it correctly before I go that route. If I ruined the drivers by having it wired wrong I don't want to do it again. Thanks in advance.
Find all posts by this user
Quote this message in a reply
03-20-2019, 06:43 PM
Post: #2
RE: Stepper motors wont move
hmm... Have you tried the motors somewhere else? How much current do they demand to move? (current/per coil). Do you have any other motor you can try with the Eggbot? Even if the motors have been connected "incorrectly" you should see them moving, or at least buzzing...
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)