Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Inkscape PY does not work
01-04-2019, 07:10 AM (This post was last modified: 01-04-2019 07:35 AM by Chris.)
Post: #3
RE: Inkscape PY does not work
(01-03-2019 08:30 PM)JJrobots JP Wrote:  Check this thread: http://forums.jjrobots.com/showthread.php?tid=1199 (point 3: replacing the eggbot.py file)

now its:

Code:
Unable to find an Eggbot on any serial port. :(

is there a way to check all function without that inkscape?
And could I edit the COM Port into the config file?
Something strange thats happening during flashing is:

Code:
...Erzwinge Reset durch öffnen/schließen mit 1200 bps auf dem Port [b]COM10[/b]
PORTS {COM1, COM10, } / {COM1, } => {}
PORTS {COM1, } / {COM1, COM9, } => {COM9, }
[b]Found upload port: COM9[/b]
...
         Using Port                    : COM9
         Using Programmer              : avr109
         Overriding Baud Rate          : 57600

it seems it swaps COM Ports during flashing (going with the hardware change sound)
I also went through reinstalling the Leonardo, although i dont think theres the problem. no change.
I checked the serial monitor command and the stepper turns, but at the end i hear one motor still chirping, it seems to be the Pen Stepper. It only stops when i reset the leonardo
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Inkscape PY does not work - Chris - 01-03-2019, 08:10 PM
RE: Inkscape PY does not work - Chris - 01-04-2019 07:10 AM
RE: Inkscape PY does not work - Chris - 01-04-2019, 09:40 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)