Possible to use stepper dirvers with THB6128 chip ?
|
05-12-2018, 07:45 AM
Post: #1
|
|||
|
|||
Possible to use stepper dirvers with THB6128 chip ?
Hi!
I have some Raps128 stepper drivers that I did plan to use on my brain shield. http://doku.radds.org/dokumentation/raps128/ There is two thisngs that may cause problems? 1. Raps128 need inverted activation signal Enable = HIGH (at Pololu drivers enable = LOW, invert in firmware!) - possible to set in the code? 2. Stepping mode - if default mode is 1/16 that is 1/128 on the Raps128 = to high/low torque If the default stepping mode on the brain is 1/16 - is it possible to alter the mode? Or do I have to order some A4988 ? |
|||
05-12-2018, 09:32 AM
Post: #2
|
|||
|
|||
RE: Possible to use stepper dirvers with THB6128 chip ?
I have some silensioso stepper drivers that I may try.
Seperate power2.1A, optical shielded, can set stepping mode on the drivers, mont on the motors.. But have to modify the gode to support inverter start signal http://ooznest.co.uk/Silencioso-Stepper-Motor-Driver |
|||
05-12-2018, 06:53 PM
(This post was last modified: 05-12-2018 06:54 PM by @mundsen.)
Post: #3
|
|||
|
|||
RE: Possible to use stepper dirvers with THB6128 chip ?
My fix:
Cut MS1 and MS2 pins on my stepper drivers (MS1 = Low, Ms2 = low, Ms3 = High = 1/16 stepping mode) Did reverse Normal mode in the BROBOT_EVO2 file (arduino editor) Made a test "frame" for my Rower Bot - simple to adjust.. I plan to use this for testing. When I find how I like the setup, I`ll design a new frame. Now I`ll add a LiPo and start testing/tuning.. |
|||
05-14-2018, 08:48 AM
Post: #4
|
|||
|
|||
RE: Possible to use stepper dirvers with THB6128 chip ?
I`m going to test a pair of Silensioso stepper drivers for my "Rower" robot. Mounted on the stepper motors Seperate power 12-24V max 2.1A All inputs are opto isolated Supports 3.3 and 5V logic = A flexible test plattform, more current and more torque https://www.reprapdiscount.com/index.php...tachment=2 |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)