Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Eraser servo problems
05-24-2018, 11:49 AM
Post: #8
RE: Eraser servo problems
I connected the servos as shown on your picture: https://imgur.com/Bf6FfuT the result isn't that good either, the robot should write test but as you can see here it is even worse https://youtu.be/G4A13rxiR_w

After that I reconnected the Servo to the old position: https://imgur.com/crD5v23 and start a new Job he writes much cleaner but not perfect. https://youtu.be/gyXzAIv67Is

In both version the cleaner moves to the left and hits the 3D printed part (should also be audible):

(05-23-2018 07:00 PM)JJrobots JP Wrote:  By the way: How did the plastic part got broken? During the assembly process? Did it get broken easily?
The how did it break is hard to answer - I think it has brocken due to the eraser hits the left side (Left Glass Holder and the X Axe Holder) 3D Printet Parts as you can see in the Videos. The other possible way this could be damaged, would be transporting the robot from location A to B by a co-worker.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Eraser servo problems - THATJOSHGUY - 04-20-2018, 11:23 AM
RE: Eraser servo problems - JJrobots JP - 04-23-2018, 05:03 PM
RE: Eraser servo problems - THATJOSHGUY - 04-24-2018, 04:52 PM
RE: Eraser servo problems - ValionAG - 05-23-2018, 06:29 AM
RE: Eraser servo problems - JJrobots JP - 05-23-2018, 09:03 AM
RE: Eraser servo problems - ValionAG - 05-23-2018, 10:19 AM
RE: Eraser servo problems - JJrobots JP - 05-23-2018, 07:00 PM
RE: Eraser servo problems - ValionAG - 05-24-2018 11:49 AM
RE: Eraser servo problems - JJrobots JP - 05-24-2018, 05:35 PM
RE: Eraser servo problems - angel43 - 06-02-2018, 01:30 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)