Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Servo speed
03-12-2020, 03:54 PM
Post: #19
RE: Servo speed
The key is to set the PEN UP and DOWN positions correctly adjusting their parameters. Every PEN has it own mass and the retraction behaviour will vary depending on it. The UP position should leave the tip of the PEN just mm away from the egg/ball surface
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Servo speed - clocey - 02-25-2018, 01:33 AM
RE: Servo speed - JJrobots JP - 02-26-2018, 05:01 PM
RE: Servo speed - clocey - 02-27-2018, 03:43 AM
RE: Servo speed - JJrobots JP - 03-02-2018, 12:54 PM
RE: Servo speed - clocey - 03-06-2018, 07:56 PM
RE: Servo speed - JJrobots JP - 03-13-2018, 12:57 PM
RE: Servo speed - preloi - 03-18-2018, 01:18 PM
RE: Servo speed - clocey - 03-20-2018, 04:46 PM
RE: Servo speed - clocey - 03-26-2018, 12:48 AM
RE: Servo speed - JohnQ - 03-27-2018, 11:03 AM
RE: Servo speed - clocey - 03-27-2018, 10:38 PM
RE: Servo speed - JJrobots JP - 04-27-2018, 12:17 AM
RE: Servo speed - LanePanet - 01-03-2019, 06:28 PM
RE: Servo speed - rhill051 - 03-26-2019, 02:50 AM
RE: Servo speed - clocey - 03-26-2019, 08:31 PM
RE: Servo speed - maddin-la - 02-27-2020, 09:50 AM
RE: Servo speed - LOlsen - 03-10-2020, 07:31 PM
RE: Servo speed - LOlsen - 03-11-2020, 01:35 PM
RE: Servo speed - JJrobots JP - 03-12-2020 03:54 PM
RE: Servo speed - LOlsen - 03-12-2020, 05:13 PM
RE: Servo speed - LOlsen - 03-16-2020, 10:25 PM
RE: Servo speed - JJrobots JP - 03-17-2020, 05:06 PM
RE: Servo speed - LOlsen - 03-21-2020, 10:25 AM
RE: Servo speed - JJrobots JP - 03-23-2020, 01:02 PM
RE: Servo speed - JohnQ - 04-13-2020, 12:22 PM
RE: Servo speed - LOlsen - 04-19-2020, 04:21 PM
RE: Servo speed - JohnQ - 04-22-2020, 08:50 AM
RE: Servo speed - SutoJL - 06-02-2020, 05:45 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)