Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Servo speed
03-27-2018, 10:38 PM
Post: #11
RE: Servo speed
The problem I am having is the Sharpie will flip up too far and be out of position to be able to draw. I am using a rubber band as a work around and it is working well.
Find all posts by this user
Quote this message in a reply
04-27-2018, 12:17 AM
Post: #12
RE: Servo speed
You can modify the separation between the tip of the pen and the egg/ball via the SERVO UP/ SERVO DOWN parameters in the SETUP tab of the EGGBOT extension
Visit this user's website Find all posts by this user
Quote this message in a reply
01-03-2019, 06:28 PM (This post was last modified: 01-17-2019 09:58 PM by LanePanet.)
Post: #13
RE: Servo speed
hello... I ordered the gyro to support the balancing robot but have not installed it yet.
The unit draws GREAT but the pen servo moves the same speed regardless what I set on the timing page. I have also created a mini-painter that uses and UNO,an adafruit shield and longrunner motors that does not draw well but I do have good control of the servo.

turnkey pcb
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)