Post Reply 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ImportError: No module named eggbot_scan
03-21-2018, 10:52 PM
Post: #2
RE: ImportError: No module named eggbot_scan
(02-08-2018 10:03 PM)Becci.Simmons Wrote:  Initially Inkscape couldn't talk to the eggbot at all - so I followed the steps in this thread and replaced the file (step 3). Now I'm getting the error in Inkscape:

"No module named eggbot-scan"

The full message is:

Traceback (most recent call last):
File "", line 34, in <module>
import eggbot_scan
ImportError: No module named eggbot_scan

This is my first time with arduino, so I tested the upload using the Arduino IDE and Serial Monitor (step 8) and the stepper motor did move, so I don't think I've got a USB cable or port issue.

I'm running Inkscape 0.91 with the EggBot 2.7.1_Mac extensions, Arduino 1.8.5 and uploaded the Ejjduino_ARDUINO

I just reinstalled the EggBot mac extensions (which backgraded the file) and I'm back to the Error "Failed to connect to EggBot. Sad"

So I've upgraded the file again and I'm back to "No module named eggbot_scan" when I try to run any of the Eggbot Controls in Inkscape. I've looked in the folder at path /Applications/ and indeed there is no module called eggbot_scan in there. Where can I get the missing module?

thanks, Becci

Any luck with this? I'm at the exact same spot as you. . . Not entirely sure what else is needed at this point. The egg bot works just fine on my pc but I'd like it to work on my macbook air for portability
Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
RE: ImportError: No module named eggbot_scan - rhill051 - 03-21-2018 10:52 PM

Forum Jump:

User(s) browsing this thread: 1 Guest(s)