Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
X Motor not moving properly (nothing to do with belts)
02-02-2018, 06:58 PM
Post: #4
RE: X Motor not moving properly (nothing to do with belts)
Just checking but...is the X-axis stuck? Can you move it without friction? that is the only possibility here.
We have discarded:
1) Faulty motor
2) Faulty stepper motor driver

Try this: upload the CLEAR EEPROM example code from the Arduino IDE to the Arduino. Then, again the iboardbot code and configure everything again.
AND: check the Arduino Leonardo pins, maybe there is a faulty/broken soldered pin not letting the control signal to get to the Brain shield. I would discard a Brain shield problem. They are quite sturdy.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: X Motor not moving properly (nothing to do with belts) - JohnQ - 02-02-2018 06:58 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)