Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
X Motor not moving properly (nothing to do with belts)
02-01-2018, 03:05 AM (This post was last modified: 02-01-2018 03:20 AM by farfetchd.)
Post: #1
X Motor not moving properly (nothing to do with belts)
Hi,

Everything is installed, and assembled. X Motor only moves.. like 1/2 a step.

Swapped X and Y Motors, and it works correctly in other position, but once wired into the X Position with the wires (or even off with wires) the pulley only moves 1/2 a step.

Pen only goes up and down, tested with both belt on and off..

Even swapped the drivers and same thing.

Sorry forgot to mention, I also compiled a fresh 1.08 and uploaded to the board as well to test, same thing.. Y motor moves fine, X motor only does 1/2 a step.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
X Motor not moving properly (nothing to do with belts) - farfetchd - 02-01-2018 03:05 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)