Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
B-Robot Evo 2 Balancing Issues
11-09-2017, 11:17 PM
Post: #1
B-Robot Evo 2 Balancing Issues
I've built two of these robots for a class in school. They were both assembled the exact same way, but one of them seems to have a problem with balancing. It won't stand up or respond to any controls from the app. I've already checked the IMU placement and somewhat checked the debugging but I'm not sure on what's wrong and how to fix it. Help would be appreciated greatly.
Find all posts by this user
Quote this message in a reply
11-10-2017, 09:18 AM (This post was last modified: 11-10-2017 09:19 AM by PaoloP.)
Post: #2
RE: B-Robot Evo 2 Balancing Issues
Check the Vref on stepper's drivers.
[Image: A4988-adjusment1.jpg]
Visit this user's website Find all posts by this user
Quote this message in a reply
11-10-2017, 09:54 AM
Post: #3
RE: B-Robot Evo 2 Balancing Issues
Does it behave like this video during the start-up?: https://www.jjrobots.com/wp-content/uplo...-1.mp4?_=1
Moving the arm and spinning the wheels a little?
If not: that means (very likely) that the IMU is not sending the correct data to the Arduino.

Does trimming the stepper motor drivers help? Are you using new batteries? (the voltage is quite important to deliver power to the motors)

If any of the things listed above help, contact us at: info@jjrobots.com
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)