Post Reply 
 
Thread Rating:
  • 1 Votes - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ESP32 Port of B-Robot_EVO2 Code
02-01-2020, 06:06 PM
Post: #91
RE: ESP32 Port of B-Robot_EVO2 Code
I would like to have a try at setting up OTA for the ESP32 version. It just seems like a nice option that makes sense. It is not so easy to find examples of OTA for AP only setups, but I managed to find this one

ESP32 OTA-AP MODE

and added it into the code. It compiles and the first connection works great. But after connecting to the phone and trying the OTA again, I am getting constant reset loop if I make a normal connection to the Brobot AP. What I tried was to set up a static IP on the laptop ( 192.168.4.2 , GW 192.168.4.1 ), and the board stopped its reset loop and I could do the OTA update without issues. This makes me think that there could be a IP address issue as the board normally only issues one IP - 192.168.4.2
Can I ask if anyone has any other ideas what could be going on here.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)