Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Modification to enable "KILL" on TouchOSC iPhone app
10-01-2017, 03:26 PM (This post was last modified: 10-01-2017 03:28 PM by jjrobots23153.)
Post: #1
Modification to enable "KILL" on TouchOSC iPhone app
I control my BROBOT using the TouchOSC app on my iPhone. One of the things I was trying to figure out was how to get the "KILL" toggle to work on page two of the BROBOT app. The code in the Network.ini file was using OSCtoggle[0] to activate the kill function. This same parameter is used to activate the PRO function on page 1. In TouchOSC editor I could see that it was using toggle2. I changed the code in the Network.ini file to use OSCtoggle[1] instead and it now works. See the pictures below for the change.


Attached File(s) Thumbnail(s)
       
Find all posts by this user
Quote this message in a reply
10-02-2017, 09:12 AM
Post: #2
RE: Modification to enable "KILL" on TouchOSC iPhone app
Good job :-)
We will take a look at that and modify the code asap.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)