Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Motor step angle 3,6 °
09-30-2016, 08:25 AM
Post: #2
RE: Motor step angle 3,6 °
Replace this code constant 46 -> 23 and 23 -> 12
Code:
#if MICROSTEPPING==16
  speed = speed_M1 * 46; // Adjust factor from control output speed to real motor speed in steps/second
#else
  speed = speed_M1 * 23; // 1/8 Microstepping
#endif
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Motor step angle 3,6 ° - NLObP - 09-30-2016, 06:46 AM
RE: Motor step angle 3,6 ° - KomX - 09-30-2016 08:25 AM
RE: Motor step angle 3,6 ° - NLObP - 09-30-2016, 02:15 PM
RE: Motor step angle 3,6 ° - KomX - 09-30-2016, 02:39 PM
RE: Motor step angle 3,6 ° - NLObP - 09-30-2016, 02:55 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)