Post Reply 
 
Thread Rating:
  • 1 Votes - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
old new B-ROBOT
07-15-2016, 07:36 PM
Post: #1
old new B-ROBOT
Hello

After a long absence, my health allows me
completed my B-Robot started long ago.
I see that a new shield is available (ESP8266)
On my B-ROBOT, I have the old shield with the RN-XV rev3.
Which file should I put in the Leonardo?
Where can I find how to set up CSOs to my tablet?
Thank you for helping me and if French fans also have a B-ROBOT
I'm happy to converse with them.
Find all posts by this user
Quote this message in a reply
07-16-2016, 10:30 AM
Post: #2
RE: old new B-ROBOT
Hi Rexty! Welcome back ;-)
You can upload the same code to the Leonardo (it is compatible). Take it from here:
https://github.com/jjrobots/B-ROBOT/tree/master/BROBOT or download the file attached to this message
.rar  BROBOT.rar (Size: 9.32 KB / Downloads: 16)

And to control the B.robot, you can use the JJrobots app (free): https://play.google.com/store/apps/detai...robots_002
Visit this user's website Find all posts by this user
Quote this message in a reply
07-17-2016, 07:27 AM
Post: #3
RE: old new B-ROBOT
Hello and thank you for your prompt reply.

I rebooted Brobot. ino in Leornardo.
I chageƩ CSOs on my tablet and JJrobots program.
I entered for both the code 87654621.
At both interfaces, I have orders.
But
the robot does not work.
A start-up servo moves a little (noise)
The yellow light is lit on leonardo
But especially on the RN-XV of green LEDs (D1) and red (D3)
lights alternate every second.

Thank you for your future councils to point me to the solution.
and good Sunday
Find all posts by this user
Quote this message in a reply
07-22-2016, 07:09 AM
Post: #4
RE: old new B-ROBOT
Hello
where can I find the wiring plan B-ROBOT
with the old Shield (Blue) JJRobots
thank you.
Find all posts by this user
Quote this message in a reply
07-22-2016, 01:38 PM
Post: #5
RE: old new B-ROBOT
Hi Rexty!
There is info here: https://github.com/jjrobots/B-ROBOT/blob...brobot.pdf
Regarding your issue "A start-up servo moves a little (noise)", are the stepper motor drivers placed? If the servo moves, the only thing to check are the motors....
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)