Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
rubber of the tires ?
12-01-2015, 10:49 PM
Post: #1
rubber of the tires ?
Hi,

What do you use exactly for the rubber of the tires ? Have you got a reference ?

I'm going to print it using Ninjaflex ? Have you got a stl file for it which fit perfectly to the tires ?

BR,
Christophe.
Find all posts by this user
Quote this message in a reply
12-02-2015, 09:11 AM
Post: #2
RE: rubber of the tires ?
o-ring
Find all posts by this user
Quote this message in a reply
12-02-2015, 10:51 AM
Post: #3
RE: rubber of the tires ?
(12-01-2015 10:49 PM)cho934 Wrote:  Hi,

What do you use exactly for the rubber of the tires ? Have you got a reference ?

I'm going to print it using Ninjaflex ? Have you got a stl file for it which fit perfectly to the tires ?

BR,
Christophe.
Use 3mm rubber o-rings. As far as I know there is not a stl for the rings. If you find one, please share it.
Find all posts by this user
Quote this message in a reply
12-06-2015, 04:16 PM (This post was last modified: 12-06-2015 04:19 PM by cho934.)
Post: #4
RE: rubber of the tires ?
(12-02-2015 10:51 AM)JohnQ Wrote:  
(12-01-2015 10:49 PM)cho934 Wrote:  Hi,

What do you use exactly for the rubber of the tires ? Have you got a reference ?

I'm going to print it using Ninjaflex ? Have you got a stl file for it which fit perfectly to the tires ?

BR,
Christophe.
Use 3mm rubber o-rings. As far as I know there is not a stl for the rings. If you find one, please share it.

Here is my first o-ring (stl file) using ninjaflex filament Wink
Inner diameter : 87 mm (to have pressure on the wheel)
Torus diameter : 4mm

stl file


Attached File(s)
.zip  o-ring_for_B-Robot.zip (Size: 96.07 KB / Downloads: 36)
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: