Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[FIXED] Not drawing correctly...
06-17-2016, 10:04 AM
Post: #8
RE: Not drawing correctly...
So. After some tinkering, the robot is working fine. I increased the voltage as described and tightened the belt. In the process I broke the fixture for the motor. This was replaced and everything tightened again. And now it is working.
Thank you everyone.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Not drawing correctly... - Korbinian - 06-01-2016, 09:45 AM
RE: Not drawing correctly... - JohnQ - 06-01-2016, 11:37 AM
RE: Not drawing correctly... - Korbinian - 06-01-2016, 12:11 PM
RE: Not drawing correctly... - Korbinian - 06-01-2016, 04:08 PM
RE: Not drawing correctly... - JJrobots JP - 06-01-2016, 04:51 PM
RE: Not drawing correctly... - Korbinian - 06-17-2016 10:04 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)