Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
not vertical
07-09-2016, 10:19 PM
Post: #4
RE: not vertical
Just finished building the BRobot, it doesn't stand vertical it kind of lean forward and keep going. where do I set the vertical value? is it MAX_TARGET_ANGLE? If I look into the serial console and have the robot vertical and I should use that value?

Thanks in advance!
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
not vertical - cho934 - 12-18-2015, 01:06 AM
RE: not vertical - cho934 - 12-18-2015, 03:38 PM
RE: not vertical - sasa999 - 12-19-2015, 12:55 PM
RE: not vertical - jimmy - 07-09-2016 10:19 PM
RE: not vertical - jimmy - 07-10-2016, 06:55 AM
RE: not vertical - JJrobots JP - 07-11-2016, 03:14 PM
RE: not vertical - jimmy - 07-11-2016, 04:08 PM
RE: not vertical - JJrobots JP - 07-11-2016, 04:10 PM
RE: not vertical - jimmy - 07-11-2016, 06:26 PM
RE: not vertical - sasa999 - 07-11-2016, 08:30 PM
RE: not vertical - jimmy - 07-11-2016, 09:11 PM
RE: not vertical - jimmy - 07-12-2016, 01:17 AM
RE: not vertical - JohnQ - 07-12-2016, 09:21 AM
RE: not vertical - jimmy - 07-12-2016, 03:36 PM
RE: not vertical - jimmy - 07-13-2016, 04:31 AM
RE: not vertical - JJrobots JP - 07-13-2016, 08:46 AM
RE: not vertical - jimmy - 07-14-2016, 04:23 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)