Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
All working except stepper motors
11-15-2015, 07:47 PM
Post: #1
All working except stepper motors
I have the OSC app installed and pushing the servo button causes the servo to cycle. I can see changes on the iPad on the serial monitor.

I don't have the robot built yet, so the gyro sensor is just sitting flat (horizontal) on the desk. If I move it around I get readings showing on the serial monitor. I thought this would be enough to trigger the motors into action but there is none whatsoever. I'm using CD player steppers for testing: 4 wire, small, known good, 5 volts op voltage.

I've also placed the sensor vertical as if the robot was laying down, waiting for a "rise-up" signal. After the 10 calibration, I move it horizontal but still nothing on the steppers, not even a "lock-up" with no movement.

Ideas?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
All working except stepper motors - queenidog - 11-15-2015 07:47 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)