Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Shield Stacking Headers
07-03-2015, 03:10 PM
Post: #4
RE: Shield Stacking Headers
You should solder all the headers provided to the B-robot brain shield. There are some pins coming from the Leonardo that are not needed (SCL/SDA, IOREF...).

Once you have soldered all the pin headers that will attach the B-robot to the Leonardo board you will have:
- 2x8 pins headers soldered in the "left side" of the B-robot brain shield
- 2x6 pins headers soldered in the "right side"
All placed on the bottom side of the Shield. Opposite face where all the electronic components are.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Shield Stacking Headers - wfbaron - 06-09-2015, 06:43 AM
RE: Shield Stacking Headers - JJrobots JP - 06-11-2015, 05:15 PM
RE: Shield Stacking Headers - wfbaron - 06-14-2015, 04:30 AM
RE: Shield Stacking Headers - JJrobots JP - 07-03-2015 03:10 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)