Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
My experience with the slider
05-31-2020, 10:24 PM
Post: #6
RE: My experience with the slider
I added a belt and it fits in nicely only had to split up the top part to make it able to place the belt.
I hope it doesn't need any belt tightening since it is a low load, but even that should be possible by making the mounting holes of the nema motor into slots. Belt is 176mm I found one seller who got them https://nl.aliexpress.com/item/326499962...web201603_
For JJ it would probably be smart to use the 20 tooth pulley, I am using the 16 version since I have that one here.

       
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: My experience with the slider - MisterMaker - 05-31-2020 10:24 PM
RE: My experience with the slider - JohnQ - 06-03-2020, 09:15 AM
RE: My experience with the slider - JohnQ - 06-04-2020, 09:11 PM
RE: My experience with the slider - JohnQ - 06-16-2020, 09:47 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)