Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
My experience with the slider
05-30-2020, 10:06 PM
Post: #3
RE: My experience with the slider
So I printed my new mounting plate. And it worked out perfectly.
I could adjust the tension on the v-wheels from too loose to too tight.
Now I had some Vibrations from friction, but I am going to let it run for a while and see how it goes then.
Maybe I shouldn't have used 3D printed V-wheels.
   
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: My experience with the slider - MisterMaker - 05-30-2020 10:06 PM
RE: My experience with the slider - JohnQ - 06-03-2020, 09:15 AM
RE: My experience with the slider - JohnQ - 06-04-2020, 09:11 PM
RE: My experience with the slider - JohnQ - 06-16-2020, 09:47 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)