Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Controller modifications questions
01-25-2020, 04:15 PM
Post: #1
Controller modifications questions
Does the control board have a pin for either of the following features I think would be good safety attributes?

1/ Limit switch(es) in case out of range settings are put in the app and the moving carriage starts to bind at either far end of the belt.

2/ A toggle switch so the carriage or the turntable motors can be manipulated by hand and any reverse current from the motors doesn't affect anything on the control board. I am usually pushing the slider by hand to the start point and I'm worried that doing that with the slider powered on leaves the control board vulnerable to EMF. Turning the slider completely off each time, to be cautious, means losing connection with the app and is time consuming.

Anyone got ideas? I know basically nothing about Arduino systems.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Controller modifications questions - Charliebrm - 01-25-2020 04:15 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)