Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
CAMERA SLIDER rail version
04-28-2020, 05:10 PM (This post was last modified: 04-28-2020 05:18 PM by Stubby.)
Post: #20
RE: CAMERA SLIDER rail version
I ordered spare steppers and received the new TMC2208 drivers also. The specs look better on them with the new finer precision stepping action. I also received the tiniest micro-aluminum heatsinks with them; if the new drivers generate less heat, they might work OK. For me, I'm going to use the much-larger blue aluminum heatsinks that I already know work fine with the older drivers. They are readily available on both Amazon and eBay; I paid $7.45US for 10; cheaper if you order from China and are willing to wait longer.

(02-11-2020 01:45 PM)JJrobots JP Wrote:  You can check the BOM here

Note: this new BOM shows the new stepper drivers, but with the old blue aluminum heatsinks, not those much smaller ones you are actually shipping that I just received. Which ones are you going to standardize going forward on for the newer better stepper drivers? Thanks for clarifying.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
CAMERA SLIDER rail version - JJrobots JP - 12-02-2019, 10:50 AM
RE: CAMERA SLIDER rail version - Oki - 01-26-2020, 11:48 PM
RE: CAMERA SLIDER rail version - Oki - 02-06-2020, 05:37 PM
RE: CAMERA SLIDER rail version - Oki - 02-09-2020, 09:56 PM
RE: CAMERA SLIDER rail version - adrik22 - 02-12-2020, 05:27 PM
RE: CAMERA SLIDER rail version - adrik22 - 02-24-2020, 04:01 AM
RE: CAMERA SLIDER rail version - Stubby - 07-31-2020, 11:16 PM
RE: CAMERA SLIDER rail version - Oki - 02-25-2020, 11:34 PM
RE: CAMERA SLIDER rail version - hami - 03-01-2020, 07:56 PM
RE: CAMERA SLIDER rail version - Stubby - 04-28-2020 05:10 PM
RE: CAMERA SLIDER rail version - berlib - 08-11-2020, 03:02 AM
RE: CAMERA SLIDER rail version - berlib - 08-17-2020, 02:32 AM
RE: CAMERA SLIDER rail version - berlib - 08-19-2020, 10:15 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)