Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Servo not able to stand robot
02-07-2019, 05:05 PM
Post: #3
RE: Servo not able to stand robot
(02-06-2019 10:01 PM)JohnQ Wrote:  Hmmm. Does the arm shakes a little while driving? Is there any "pushing up force" difference when the B-robot is laying down on any particular side?
The servo, yes could be damaged (gears) Unlikely but possible! Contact jjRobots, they have a great customer service.

No. Shakes when calibrating but runs around with arm straight up just like my other one after calibration.
Hits the ground and lifts a little when it falls (same each direction) But not enough to stand it up.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Servo not able to stand robot - rgray - 02-05-2019, 04:16 PM
RE: Servo not able to stand robot - JohnQ - 02-06-2019, 10:01 PM
RE: Servo not able to stand robot - rgray - 02-07-2019 05:05 PM
RE: Servo not able to stand robot - rgray - 02-12-2019, 02:25 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)