Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
New board- can't connect... Solid green light only
06-15-2018, 09:03 AM
Post: #3
RE: New board- can't connect... Solid green light only
Check the end of the assembly guide here: https://www.jjrobots.com/iboardbot-assem...tructions/ (My iBoardbot is now drawing or wiping the glass correctly. What is going on? )
There are photos of the servos set in the right place. If you move the iboardbot, they can get loose and you may need to re-adjust them again
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: New board- can't connect... Solid green light only - JohnQ - 06-15-2018 09:03 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)