Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Possible to use stepper dirvers with THB6128 chip ?
05-12-2018, 06:53 PM (This post was last modified: 05-12-2018 06:54 PM by @mundsen.)
Post: #3
RE: Possible to use stepper dirvers with THB6128 chip ?
My fix:

Cut MS1 and MS2 pins on my stepper drivers (MS1 = Low, Ms2 = low, Ms3 = High = 1/16 stepping mode)

Did reverse Normal mode in the BROBOT_EVO2 file (arduino editor)

   

Made a test "frame" for my Rower Bot - simple to adjust.. I plan to use this for testing. When I find how I like the setup, I`ll design a new frame.

   

Now I`ll add a LiPo and start testing/tuning..
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Possible to use stepper dirvers with THB6128 chip ? - @mundsen - 05-12-2018 06:53 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)