Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Connect to personal WIFI
02-18-2018, 05:26 PM
Post: #2
RE: Connect to personal WIFI
Just guessing wildly: The JJRobots App always sends UDP control parameters to 192.168.4.1 (maybe there's even some logic inside to send to x.x.x.1 always based on the subnet the IP belongs to). Usually that is the robot's IP when it's running in AP mode. The robot itself sends its data (angle, battery) to 192.168.4.2 (i.e TELEMETRY server) which is the first device connected to the WiFi when the robot runs in AP mode.
Probably you'd need the more generic OSC touch app (https://www.jjrobots.com/osctouch-app-configuration/) if you want to control the robot connected to an existing WLAN. At least in that app you can configure an IP address.

Hope this helps.

Best regards,
ghmartin77
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Connect to personal WIFI - painless - 02-15-2018, 05:03 PM
RE: Connect to personal WIFI - ghmartin77 - 02-18-2018 05:26 PM
RE: Connect to personal WIFI - painless - 02-19-2018, 06:34 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)