Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Help - new DIY brobot can't be controlled by JJrobots control APP
09-19-2017, 09:54 AM
Post: #3
RE: Help - new DIY brobot can't be controlled by JJrobots control APP
(09-18-2017 06:32 PM)jpedroc Wrote:  It could be a problem with the TX-RX lines on the ESP-07. They should be sending to the Arduino the control commands. Check them again. You can alternatively DEBUG the B-robot connected to the Arduino IDE and check if it is getting something from the WIFI module. Check the DEBUG options in the B-robot CODE

I have found the solution somehow. Thank you sir for your prompt reply. Yes indeed the TX and RX is working because it can send the AT commands and display the response on the serial monitor. The problem is solved when I uploaded the latest Brobot_evo2 Arduino sketch. (I used the older version of it, very noob of me eh!) Now, its working perfectly well. I am really enjoying playing and controlling it around my room. I'm currently building my smaller version of the B-robot Evo2.

Thank you for this wonderful project-cheers from the Philippines
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Help - new DIY brobot can't be controlled by JJrobots control APP - arielclemente - 09-19-2017 09:54 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)