Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Help - new DIY brobot can't be controlled by JJrobots control APP
09-18-2017, 06:32 PM
Post: #2
RE: Help - new DIY brobot can't be controlled by JJrobots control APP
It could be a problem with the TX-RX lines on the ESP-07. They should be sending to the Arduino the control commands. Check them again. You can alternatively DEBUG the B-robot connected to the Arduino IDE and check if it is getting something from the WIFI module. Check the DEBUG options in the B-robot CODE
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Help - new DIY brobot can't be controlled by JJrobots control APP - JJrobots JP - 09-18-2017 06:32 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)