Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
changing the size
11-03-2018, 05:22 PM
Post: #1
changing the size
Hello all
First thank you for this great project.
I wanna make it .
I read some forums and get little confused.
Can I change table and steel bar size ?
if I change the size ,Does It work correctly? and then which file and source should I change?
HuhHuhExclamation
Find all posts by this user
Quote this message in a reply
11-06-2018, 04:03 PM
Post: #2
RE: changing the size
Yes, you can modify its size but you will need to modify as well the 3D parts, and Arduino code.
3D parts: check that you can support the new and larger board. Check the lifting servo clearance and extend the servo cables.
Arduino: Increase the drawing are in relation with the drawing surface.
Visit this user's website Find all posts by this user
Quote this message in a reply
11-29-2018, 08:10 AM
Post: #3
RE: changing the size
(11-06-2018 04:03 PM)JJrobots JP Wrote:  Yes, you can modify its size but you will need to modify as well the 3D parts, and Arduino code.
3D parts: check that you can support the new and larger board. Check the lifting servo clearance and extend the servo cables.
Arduino: Increase the drawing are in relation with the drawing surface.
Thanks for your reply
I have make the brain shield
now ,I want to model the air hockey table with SOLIDWORK but I cannt use STL file which you put on website, can you give me another format file???
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)