Standard Servo possible?? - Printable Version

+- JJRobots COMMUNITY (http://forums.jjrobots.com)
+-- Forum: JJrobots (/forumdisplay.php?fid=1)
+--- Forum: B-Robot (/forumdisplay.php?fid=2)
+--- Thread: Standard Servo possible?? (/showthread.php?tid=2553)

Standard Servo possible?? - Greengecko - 06-05-2020 03:05 PM

For my new body for b-robot I need to know if it is possible to use an standard servo instead of the original 9g mini servo? The Devia board provides 1,5A pro servo output, but don't know if this enough.

RE: Standard Servo possible?? - JJrobots JP - 06-07-2020 01:51 PM

You can use any servo you want but make sure it is not demanding more than 1.5 A. If it is close to that value I would recommend using a heatsink on top of the 5V regulator on the board.