JJRobots COMMUNITY
changing the size - Printable Version

+- JJRobots COMMUNITY (http://forums.jjrobots.com)
+-- Forum: JJrobots (/forumdisplay.php?fid=1)
+--- Forum: Air- hockey Robot EVO (/forumdisplay.php?fid=4)
+--- Thread: changing the size (/showthread.php?tid=1825)



changing the size - p990 - 11-03-2018 05:22 PM

Hello all
First thank you for this great project.
I wanna make it .
I read some forums and get little confused.
Can I change table and steel bar size ?
if I change the size ,Does It work correctly? and then which file and source should I change?
HuhHuhExclamation


RE: changing the size - JJrobots JP - 11-06-2018 04:03 PM

Yes, you can modify its size but you will need to modify as well the 3D parts, and Arduino code.
3D parts: check that you can support the new and larger board. Check the lifting servo clearance and extend the servo cables.
Arduino: Increase the drawing are in relation with the drawing surface.


RE: changing the size - p990 - 11-29-2018 08:10 AM

(11-06-2018 04:03 PM)JJrobots JP Wrote:  Yes, you can modify its size but you will need to modify as well the 3D parts, and Arduino code.
3D parts: check that you can support the new and larger board. Check the lifting servo clearance and extend the servo cables.
Arduino: Increase the drawing are in relation with the drawing surface.
Thanks for your reply
I have make the brain shield
now ,I want to model the air hockey table with SOLIDWORK but I cannt use STL file which you put on website, can you give me another format file???