06-18-2016, 02:38 PM

Hi,

I was thinking about how to facilitate larger boards ( > 40x40) while the resolution stays the same.

This is what I came up with, and I was wondering how you (jjrobots as maintainers of the code, and others to see if my ideas have any merit)

At the moment, the protocol specifies that fields with a value > 4000 are logic commands, and values < 4000 are the coordinates.

Why not switch this logic? I doubt there will be more than 4000 logic commands (now there are 8 commands), but this will allow for far larger coordinate pairs.

Is this feasible?

Meine

I was thinking about how to facilitate larger boards ( > 40x40) while the resolution stays the same.

This is what I came up with, and I was wondering how you (jjrobots as maintainers of the code, and others to see if my ideas have any merit)

At the moment, the protocol specifies that fields with a value > 4000 are logic commands, and values < 4000 are the coordinates.

Why not switch this logic? I doubt there will be more than 4000 logic commands (now there are 8 commands), but this will allow for far larger coordinate pairs.

Is this feasible?

Meine