JJRobots COMMUNITY

Full Version: is it possible for little smaller table
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
I want to order the parts to assemble an airhockey table for my daughter, but it is hard to get suggested table, I found little bit smaller table in local, the size is 81CM*42CM. for the algorithm of phone camera, is this size good or not, or there are some parameters I can tweaking for the different size of table?

Thank you
Smile
(12-27-2016 04:50 PM)yuqian Wrote: [ -> ]I want to order the parts to assemble an airhockey table for my daughter, but it is hard to get suggested table, I found little bit smaller table in local, the size is 81CM*42CM. for the algorithm of phone camera, is this size good or not, or there are some parameters I can tweaking for the different size of table?

Thank you
Smile
Hi!
Could you provide a link (or photos) to that air hockey table so we can take a look to it?
Why is difficult to get the recommended Air hockey table? What kind of problem did you have?
The main reason is shipping cost too high even up to the table cost Wink, I am living in Beijing China, here is the local table picture, FYI
thanks.
(12-29-2016 03:03 PM)yuqian Wrote: [ -> ]The main reason is shipping cost too high even up to the table cost Wink, I am living in Beijing China, here is the local table picture, FYI
thanks.
Yes, you can use that table Big Grin. Actually, that was one of many air hockey tables we have used during the prototyping stage.
How about this table?

https://www.walmart.com/ip/HX40-Air-Hockey/24190975

Would it work?

It seems its dimensions are 40L x 20W x 3.9H in which is 101.6 x 50.8 x 9.9 cm.

I am good at tweaking 3D print models, so that's not an issue. I am only concerned about the rod sizes.
You would need to change the rods (use larger ones). But "might" work ;-)
Reference URL's